RC Tutor
  • Home
  • Tutorials
    • 5.8GHz FPV Monitor
    • ESC Flashing
    • iPhone FPV
    • MultiWii Tutorial
  • Projects
    • Polakium SSH170
    • 3D Printed Quadcopter
    • DJI Quadcopter
    • X250 Quadcopter
    • Foam Board Wing
    • $160 FPV Setup
    • Rocket Quadcopter
  • Store
  • Contact

The Top Plate

Like I mentioned before, the top plate of the X250 Quadcopter has an integrated MWC board.  The board has several slots cut through it for allowing wires to pass through and this is what I used for connecting my ESC wires.  Before I finished connecting everything, I took my Orange RX and made it a little smaller by taking it out of its case and heat shrinking it.  I placed the receiver between the top and bottom plate along side the ESC wires. 
Picture
Picture
After the receiver was in place, I secured the top plate using the remaining bolts and standoffs.  I also added the protective ring above the top plate. 
Picture
Picture
To finish off the quadcopter, I added the props onto all 4 motors and attached a small battery to the underside.
Picture
Picture

< Previous
Back to Project
Powered by Create your own unique website with customizable templates.